[CCNAv6 S1] 4.2.4.4 Packet Tracer - Connecting a Wired and Wireless LAN







Nhận xét

Đăng nhận xét

Bài đăng phổ biến từ blog này

[CCNAv6 S2] 2.2.2.4 Packet Tracer - Configuring IPv4 Static and Default Routes

Hình ảnh
Packet Tracer - Configuring IPv4 Static and Default Routes Addressing Table Objectives Part 1: Examine the Network and Evaluate the Need for Static Routing Part 2: Configure Static and Default Routes Part 3: Verify Connectivity Background In this activity, you will configure static and default routes. A static route is a route that is entered manually by the network administrator to create a reliable and safe route. There are four different static routes that are used in this activity: a recursive static route, a directly attached static route, a fully specified static route, and a default route. Part 1:     Examine the Network and Evaluate the Need for Static Routing a.     Looking at the topology diagram, how many networks are there in total? b.    How many networks are directly connected to R1, R2, and R3? c.     How many static routes are required by each router to reach networks that are not directly ...
Đọc thêm

[CCNAv6 S4] 3.4.2.5 Packet Tracer - Troubleshooting GRE

Hình ảnh
Packet Tracer – Troubleshooting GRE Addressing Table Objectives ·         Find and Correct All Network Errors ·         Verify Connectivity Scenario A junior network administrator was hired to set up a GRE tunnel between two sites and was unable to complete the task. You have been asked to correct configuration errors in the company network. Part 1:     Find and Correct All Network Errors. Part 2:     Verify Connectivity Step 1:     Ping PCA from PCB. Attempt to ping the IP address of PCA from PCB. The ping should be successful. Step 2:     Trace the path from PCA to PCB. Attempt to trace the path from PCA to PCB. Note the lack of public IP addresses in the output. Configuration RA: enable configure terminal interface tunnel 0  no ip address interface g0/0  no ip address  ip address 172.31.0.1 255.255.255.0 interface tu...
Đọc thêm

[CCNAv6 S3] 10.2.2.3 Packet Tracer - Troubleshooting Single-Area OSPFv2

Hình ảnh
Packet Tracer – Troubleshooting Single-Area OSPFv2 Addressing Table Scenario In this activity, you will troubleshoot OSPF routing issues using ping and show commands to identify errors in the network configuration. Then, you will document the errors you discover and implement an appropriate solution. Finally, you will verify end-to-end connectivity is restored. Troubleshooting Process 1.     Use testing commands to discover connectivity problems in the network and document the problem in the Documentation Table. 2.     Use verification commands to discover the source of the problem and devise an appropriate solution to implement. Document the proposed solution in the Documentation Table. 3.     Implement each solution one at a time and verify if the problem is resolved. Indicate the resolution status in the Documentation Table. 4.      If the problem is not resolved, it may be necessary to first remove th...
Đọc thêm