Hacklmht.com Là Lừa Đảo

Nhận xét

Đăng nhận xét

Bài đăng phổ biến từ blog này

[CCNAv6 S2] 2.2.2.4 Packet Tracer - Configuring IPv4 Static and Default Routes

Hình ảnh
Packet Tracer - Configuring IPv4 Static and Default Routes Addressing Table Objectives Part 1: Examine the Network and Evaluate the Need for Static Routing Part 2: Configure Static and Default Routes Part 3: Verify Connectivity Background In this activity, you will configure static and default routes. A static route is a route that is entered manually by the network administrator to create a reliable and safe route. There are four different static routes that are used in this activity: a recursive static route, a directly attached static route, a fully specified static route, and a default route. Part 1:     Examine the Network and Evaluate the Need for Static Routing a.     Looking at the topology diagram, how many networks are there in total? b.    How many networks are directly connected to R1, R2, and R3? c.     How many static routes are required by each router to reach networks that are not directly ...
Đọc thêm

[CCNAv6 S4] 3.4.2.5 Packet Tracer - Troubleshooting GRE

Hình ảnh
Packet Tracer – Troubleshooting GRE Addressing Table Objectives ·         Find and Correct All Network Errors ·         Verify Connectivity Scenario A junior network administrator was hired to set up a GRE tunnel between two sites and was unable to complete the task. You have been asked to correct configuration errors in the company network. Part 1:     Find and Correct All Network Errors. Part 2:     Verify Connectivity Step 1:     Ping PCA from PCB. Attempt to ping the IP address of PCA from PCB. The ping should be successful. Step 2:     Trace the path from PCA to PCB. Attempt to trace the path from PCA to PCB. Note the lack of public IP addresses in the output. Configuration RA: enable configure terminal interface tunnel 0  no ip address interface g0/0  no ip address  ip address 172.31.0.1 255.255.255.0 interface tu...
Đọc thêm

[CCNA Security v2] 6.3.1.3 Packet Tracer - Layer 2 VLAN Security

Hình ảnh
Packet Tracer - Layer 2 VLAN Security Objectives ·         Connect a new redundant link between SW-1 and SW-2. ·         Enable trunking and configure security on the new trunk link between SW-1 and SW-2. ·         Create a new management VLAN (VLAN 20) and attach a management PC to that VLAN. ·         Implement an ACL to prevent outside users from accessing the management VLAN. Background / Scenario A company’s network is currently set up using two separate VLANs: VLAN 5 and VLAN 10. In addition, all trunk ports are configured with native VLAN 15. A network administrator wants to add a redundant link between switch SW-1 and SW-2. The link must have trunking enabled and all security requirements should be in place. In addition, the network administrator wants to connect a management PC to switch SW-A. The administrator would like to enable the management PC to connect to ...
Đọc thêm